OEM Germany Parts

Engine Valve Control Rocker Shaft Hardware Set with RSR Rocker Arm O- Ring Seals - (1965-1994) PORSCHE 911 / 914-6 / 930 / 964 / Turbo - (Solid Rockers Only) Original Equipment Suppliers / PATRICK MS USA - MSRP: $69.82

Set Includes: 2) RSR Shaft O-Rings, 1) Shaft Bolt, 1) Shaft Bushing, & 1) Shaft Nut. 12 Qty. Per Engine

Seal - Quarter Panel Extension to Body (5 Meter Roll) - (1978-1989) PORSCHE 911 / 930 Turbo - O.E.M.

PORSCHE Part Number: 000 043 204 81

Door Seal - Left / Right - (1965-1994) PORSCHE 911 / Turbo - O.E.M. Germany - MSRP: $177.44
+ Replaces PN: 911 531 095 02

Windshield Seal / Sealing Frame - Front - PORSCHE 911 / 930 Turbo - OE Supplier - MSRP: $144.07 + For cars with trim frame

PARKING BRAKE SHOE SET (4) - PARKING BRAKE - PORSCHE 911 THRU '89 / 912 / 912 E / 911 TURBO THRU '77 - (4 PER CAR) - LIST: $ 215.12

Electrical Quick Disconnect Battery Terminal - Twist knob and cut off power to starter - Ideal for less frequently driven vehicles.

Restrictor for Oil Tank Breather Hose - (1981-1989) PORSCHE 911 / 930 - O.E.M. - MSRP: $19.49

Intermediate Intake Manifold Flange - (1984-1989) 911 Carrera - 3.2L DME - (Insulator Block In Between the Intake Manifold Gaskets) - O.E.S. Germany - MSRP: $6.64 Each (+6 Per Engine)

Flywheel - 901 Transmission / 215 mm / 6 Bolt Crankshaft - Single Mass Casting with Integral Starter Ring Gear - (1965 (From Engine# 901 639) -1969) PORSCHE 911 / (1970-1972) PORSCHE 914-6 - (12.05 Lbs. / 5.47 Kg.) - O.E.M. GERMANY - MSRP: $1002.14

Flywheel - Porsche 911 / G50, 1987-1989, 240 MM, 9 Bolt Crankshaft, 10.65 LBS, NEW O.E.M., MSRP: $739.03

Flywheel - 225mm (1979-1983) PORSCHE 911 SC / 915 Transmission - (10.65 Lbs. | 4.83 Kg) - OEM SEBRO - MSRP: $736.95

+ NOTE: 1979 911 From Engine #6292281 (Except California models), Engine #6591576 (Only California models)

Valve Cover Gasket Set - (1968-1992) PORSCHE 911 / 930 Turbo / (1970-1972) 914-6 - O.E.M. -

+ Contains: 2 Upper Gaskets (Gray), 2 Lower Gaskets (Green w/ Silicon Bead), Cover Nuts & Washers

Engine Valve Cover Gasket Set - PORSCHE 964 (M64.01/02/03) - Non Turbo Models - O.E.M. KIT - MSRP: $87.19 + Note: Does not include sealing washers - 999 025 193 30

Bolt - Flywheel Ring Gear to Clutch Pressure Plate (8 X 45 mm) - For Single Mass Flywheel Conversion - PORSCHE 911 Euro RS / GT2 RS / GT3 - O.E.M. Germany - MSRP: $1.02 Each / +9 Per Car

+ Replaces PN: N 014 715 3
+ Tightening Torque: 23 Nm (17 ftlb)

Wheel Bolt Stud - M14 x 1.50 x 66 Length - 911 Turbo / 924 / 944 - OE Supplier - MSRP: $10.77

Crankshaft to Flywheel Bolt - M10 x 1.25 - PORSCHE 928 / 964 / 993 / 996 / 997 / GT3 / Euro RS / 240mm Single Mass Only - OEM GERMANY

+ Torque Spec. : 1st Stage: 40nm (29.50 ft lbs.) / 2nd Stage: 90nm (65 ft lbs.)

Flywheel Bolt - Crankshaft to Flywheel - M10 X 1.25 - PORSCHE 911 / 930 TURBO / 924S / 944 / 968 / CARRERA GT - 9 Per Car - O.E.M., MSRP: $6.01
+ Torque Specification: 90 Nm (65 Ft Lb)

Transmission & Differential Drain / Fill Plug with Magnet - M22 Tapered Thread - PORSCHE 356 (519 / 716) / 911 (901 / 911 / 915) / 914 (901) / 911 Turbo (930) / 928 - O.E.M. Germany - MSRP: $NA
+ Note: Original gear housing plug (without magnet) is no longer available. Use version with magnet for both locations.
+ Also See PN: 999 019 02 AN08 - Screw Plug Adapter to AN-08

Ignition Distributor Belt - (1990-1998) PORSCHE 911 / 964 / 993 - OEM GATES - MSRP: $10.15 + Use with PN: 930 602 922 00 - Gear Pin

Engine Oil Cooler - (1970-1972) PORSCHE 914-6 - Reproduction - High Efficiency Aluminum Core - OEM Germany

+ Features: 30mm Male Feed Pipe Union connects to PN: 901 107 710 04 - Hose Line Intake Pipe

Engine Oil Filler Cap (Bayonet Type Cap) - (1973-1998) 911 / 930 / 964 / 993 / Turbo - GERMAN - MSRP: $15.16

Oil Supply Pipe from Oil Thermostat to Front Cooler Supply Line - (1974-1989) PORSCHE 911 / 930 Turbo - O.E.M. Germany

Oil Pressure Return Pipe from Oil Thermostat to Front Cooler Return Line - (1974-1989) PORSCHE 911 / 930 Turbo - O.E.M. Germany - MSRP: $633.65

Flywheel & Clutch Package
3.6L DME (964/993) Engine Conversion for 915 Transmissions
- Includes all necessary Flywheel and Clutch parts when Converting to a 3.6L DME Engine using a 915 Transmission.

Includes:
- Sport Lightweight Single Mass Flywheel
- Centerforce Clutch Kit
- Crankshaft Seal
- Pilot bearing and hardware.

Transmission Main Shaft Nose Bearing - (1994-1998) PORSCHE 993 - Cylindrical-Roller Bearing 25x52x15 mm - O.E.M. - MSRP: $574.48

Transmission Gasket Set - G50 Type (1987-1998) 911, 5 & 6 Speed Manual Trans - SSF KIT - MSRP: $182.10
+ REPLACES PN: 950 300 911 00